![]() I do not make any warranties about the completeness, reliability and accuracy of this information. It might not be suitable for your environment. This article will show you how to upgrade the firewall efficiently, based on my personal experience. This could potentially result in SNMP data collection issues where traffic from a Collector to its monitored devices flows across a Palo Alto Firewall.※ Caution: I strongly recommend you refer to the Palo Alto Networks (PAN) official site first. This discard session would then block ALL subsequent SNMP responses from the device back to the Collector that are using the same port on the Collector, until a Collector restart or other event allows the discard session to expire (after no traffic for 30-60 seconds). This is evidenced by a discard session on the firewall for the response packet (that is, discard UDP from device:snmp port -> collector:highport). In some cases, Palo Alto Firewalls allow SNMP requests from a Collector to a device, but block the response from the device back to the Collector. For more information on setting properties, see Resource and Instance Properties. ![]() It is easiest to set this property at the root level of your LogicMonitor account this allows the DataSources to connect via the API. Note: Ensure this property is set on all Palo Alto devices, including the Panorama management server. Copy the key value and use it as the value for a device property named.The key should be formatted similar to the following: gJlQWE56987nBxIqyfa62s23RtYuIo2BgzEA9UOnlZBhU. The result will be an XML block that contains the key.Any special characters in the password must be URL encoded (your browser will most likely do this for you.) Note: Replace firewall, username, and password in the above URL with the appropriate values.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |